1996-2002 Toyota 4Runner Rear Adjustable Track Panhard bar

1996–2002 Toyota 4Runner Rear Adjustable Track Bar | Stock to 6" Lift

When you lift a solid rear axle 4Runner, the rear axle shifts laterally — off-center in the wheel wells, causing dog-tracking, uneven tire wear, and brake pull. The Apoc Industries Rear Adjustable Track Bar corrects that by letting you dial in exact axle centering at any lift height. Set it, lock it, done.

Fits 1996–2002 Toyota 4Runner (4WD, solid rear axle). Built in the USA.

Features

• 1.5" Solid Steel Rod: Machined from solid bar stock — no hollow tubing, no flex.
• Adjustable Up to 6" Lift: Full range adjustment to precisely center your rear axle.
• Polyurethane Bushing Ends: Quiet, rebuildable bushing ends for long service life.
• Bolt-On Install: Uses factory mounting points — no drilling, no welding.
• Black Powder Coat Finish: Corrosion-resistant, clean look.
• USA-Made: Built by Apoc Industries.

Installation

• Est. Install Time: 1–1.5 hours
• Tools Required: Basic hand tools, tape measure, method to support axle weight
• Set length to center axle in wheel wells, tighten jam nuts
• Alignment recommended after installation

Fitment

• 1996–2002 Toyota 4Runner (4WD, solid rear axle only)
• Lift Range: Stock to 6"
• Does NOT fit: 2WD or IFS configurations

Complete Your 4Runner Build

• 1996–2002 4Runner Adjustable Trailing Arms (Full Set) — correct pinion angle and axle position
• 1996–2002 4Runner Upper Trailing Arms — upper arms sold separately
• 1996–2002 4Runner Johnny Joint Trailing Arms — maximum articulation version
• Rear Track Bar Hardware Kit — fresh hardware for a clean install
• Apoc Build Blog — Toyota suspension install guides