MUST HAVE 2-6 INCHES OF LIFT TO USE THESE CONTROL ARMS
Double adjustable controls arm use one right hand thread and one left hand thread on each control arm allowing easy adjustments to a caster angle without removing control arm. When running a leveling kit or more lift, the axle is no longer centered in the fender like stock. Adjustable control arms allow you to center axle back to stock location which helps to reduce or stop tire rubbing when turning.
Apoc Dodge Ram adjustable controls arms are a great upgrade from stock, factory controls arms work great with factory sized tires and suspension but once you go bigger you need stronger and longer controls arms to maintain correct handling. Apoc Dodge control arms are built to maintain proper suspension and steering geometry to keep your truck feeling like stock but better. When adding any amount of lift to a Dodge Ram you change your caster angles which can create dangerous steering symptoms and harder to maintain proper wheel tracking which can cause your vehicle to wonder between the lines easier. Big tires and big lifts look great but don't sacrifice handling and create a beast to keep on the road upgrade you control arm and drive with ease. Adjustable Controls arms are fully adjustable from stock all the way to 7" of lift, so if your just starting with a mild lift for now but upgrading later, these arms will suit your needs as you add more lift over time.
- 2 Upper Control Arms
- 2 Lower Control Arms
- Top Quality Polyurethane Bushings
- .250 Wall Tubing
- Bushing Ends DOM Tubing
- Uses Factory Hardware
- Grease Fitting For Each Bushing For Long Life
- 3-4 Hours
- Basic hand tools
- Jack and Jack stands
Control Arm lengths
If you are upgrading from factory control arms make sure you set the length to the correct lift size to keep your steering geometry correct. The larger the lift the longer the control arms. Don't assume what your lift size is, if you are not sure contact the lift kit manufacture to verify your lift size. The Instructions will give you the measurements to set each control arm to match your lift, an alignment is recommended after install to insure all alignment angle are proper.