This item comes with RAW metal only! You must have these coated by your preferred shop.

CNC CUT BOX STYLE ADJUSTABLE TRACTION BAR KIT

2011-16 factory U bolt plate was at the bottom of the axle U bolts nuts facing the ground like the picture below. If you have installed a lift kit, the rear U bolts may have been flipped, and the U bolt nuts moved to the top of the leaf spring.

(Some models will require removal or trimming of the skid plate on the side of the fuel tank for clearance)

Apoc's adjustable Tubular traction bars are a bolt-on kit to easily enhance the look of your Ford Super Duty PPickupand also add support for your rear suspension. Today's trucks can put some serious power to the ground, causing wheel hop and leaf spring damage, stock or lifted; your truck will benefit from a quality set of traction bars. If your truck uses lift blocks, then a set of traction bars will add stability to your rear suspension. Our simple bolt-on kit clamps around your rear axle housing and volts to your frame; drilling will require the frame mount unless you weld it on. The design team also added an adjustable end to allow adjustments for easier installation, or if you decide to lift your truck after installing our traction bars, you can adjust the traction bar.

Traction Bars are 72" in length. Axle Clamps are replaced with U-Bolt Plates to prevent axle twisting. 

Parts Included:

• 2 Frame Mounts
• 2 U Bolt mounts
• 2 Traction Bars
• Install Hardware

Install Time:

• 2.5 Hours
• Basic Hand Tools
• Drill and drill bits

 Install Instructions