REAR CONTROL ARM SET stock to 6" lifts

Apoc Jeep Wrangler rear adjustable control arms are a significant upgrade from stock, factory controls arms work great with factory-sized tires and suspension, but once you go bigger, you need more robust, longer control arms to maintain correct handling. Apoc Jeep Wrangler control arms are built to support proper suspension geometry to keep your rig handling like stock but better. When adding any amount of lift to your Jeep Wrangler, you change your pinion angles, which can create dangerous vibrations and cause premature wear to your vehicle. Big tires and lifts look great, but don't sacrifice handling, which can create a beast to keep on the street; upgrade your control arms and drive easily. Our Adjustable Controls arms are fully adjustable from stock to 5" of lift, so if you're starting with a mild lift for now but upgrading later, these arms will suit your needs as you add more lift over time.

Parts Included:

• 2 Upper Control Arms
• 2 Lower Control Arms
• Top Quality Polyurethane Bushings
• Bushing Ends DOM Tubing 
• Uses Factory Hardware
• Grease Fitting For Each Bushing For Long Life

Install Time:

• 3-4 Hours
• Basic hand tools
• Jack and Jack stands

Arm lengths

These measurements are for 2.5"-3.5" with 5 degrees caster; these measurements are starting points and might need to be adjusted for proper alignment.

Control Arm lengths 

If upgrading from factory control arms, ensure you set the length to the correct lift size to keep your steering geometry accurate. The larger the lift, the longer the control arms. Don't assume your lift size; if unsure, contact the lift kit manufacturer to verify your size. The Instructions will give you the measurements to set each control arm to match your lift; an alignment is recommended after installation to ensure proper alignment angles.